When servicing the fuel system, do not smoke or allow
open flame or sparks in the vicinity. Gasoline is extremely
flammable and highly explosive, which could result in
death or serious injury. (00330a)
1. See the service manual to perform the following general-
ized steps:
a. Remove seat. Retain all seat mounting hardware.
b. Remove the ECM caddy from the top of the battery.
c. Disconnect both battery cables, negative battery cable
first.
d. Remove battery.
e. Remove fuel tank console. Remove fuel tank.
f. See Figure 1. Remove the wire trough cover.
g. Remove right side cover.
h. Remove left side cover.
i. Remove the two bolts attaching the electrical caddy
under the left side cover.
Figure 1.Wire Trough
AMPLIFIER INSTALLATION
1. Remove all items from the right saddlebag. Remove
saddlebag. Remove bag liners (if present).
NOTE
To minimize damage to paint during cutting and drilling. use
masking tape.
2. See Figure 2. Place the saddlebag on a protected surface
with the mounting (inboard) side facing up.
Cut openings for amplifier connector [289-1]:
See Figure 2, Items 4 and 5.
3. Use the template (1) to cut the openings in the saddlebag
for the fairing lower amplifier 18-way flanged connector
[289-1A].
a. If saddlebag lid speakers are present from a previous
installation, right side speaker wires could be in the
connector cutout location. Remove the wire and
grommet.
b. Carefully cut the opening (4) in the template (1) for
connector [289-1A].
c. Place the template on the saddlebag. Align the
grommet (2) and latch fastener (3) openings. Trace
the cut outline (4) for connector [289-1A] onto the
saddlebag.
d. Drill two pilot holes (5) for the connector flange
mounting locations.
e. Remove template. Verify size of opening (4) with the
18-way flanged connector [289-1A] on the saddlebag
harness (see Figure 11, Item 7) from the kit.
f. Cut the opening (4) for connector [289-1A] into the
saddlebag wall.
g. Drill two 9/32 in (7.25 mm) mounting holes (5).
1. Template
2. Saddlebag rear grommet
3. Saddlebag rear latch fastener (4)
4. Connector [289-1A] cutout
5. Connector [289-1A] flange mounting hole (2)
6. Connector [289-2A] cutout
7. Connector [289-2A] flange mounting hole (4)
8. Connector [C36A] cutout (if needed)
9. Connector [C36A] flange mounting hole (4) (if
needed)
Figure 2. Right Saddlebag Drilling For Stage II Amplifier
Installation
Cut openings for four-way connector [289-2]:
See Figure 2, Items 6 and 7.
NOTE
DO NOT drill four-way connector openings (Items 8 and 9)
unless using saddlebag speakers.
2 of 8-J06051
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals